Introduction by the laminator supplier: What should you do if your laminator gets stuck?

Shrink wrapping machine supplier Let me tell you, sealing machines use high temperature and high pressure to bond the sealed item into a plastic film—the underlying principle isn't complicated at all. Thanks to improvements in both the manufacturing process and the properties of raw materials, the issues we used to worry about—such as foaming and surface smoothness—are now virtually nonexistent.

Why is it “almost”? Because the process involves high temperature and high pressure, which places specific requirements on the thickness of plastic films and plastic packaging. According to suppliers of sealing machines, the current standard thickness of plastic films used in household sealing machines on the market is... 7.5–12.5 microns (each sheet measures 0.075–0.125 mm; a single plastic film consists of two sheets, with a total thickness of 0.15–0.25 mm, used for quality inspection). Nowadays, plastic packaging films as thin as 6 microns or even 5 microns are available on the market. The thinner the plastic film (the fewer wires it contains), the lower the temperature required. If the temperature exceeds the threshold needed for the plastic film, high-temperature foaming will occur. The data marked by the laminator supplier are security data. Sometimes, the plastic packaging of these films may not be a problem, but the likelihood of bubbles forming on the film is relatively high. Therefore, the laminator supplier recommends using the manufacturer’s labels. After all, a single sheet of film doesn’t cost much, yet ruining a photo, a document, or even a child’s drawing would be far too costly in the long run.

The laminator supplier knows that some friends may encounter the following issue when using a laminator: laminating photos. / While the document was being sealed in the machine, it suddenly got stuck midway, making it impossible to continue sealing. We’re worried that forcibly pulling the photo out might damage it. So what should we do in this situation? Don’t worry! What should we do when the machine malfunctions? The following laminator supplier continues to bring you solutions!

When the plastic sealing machine jams due to improper operation or other reasons during operation, we can use the bonsai plastic sealing machine. Use the “shift key” to help us advance the paper. The shift key is usually located in the upper-right corner of the laminator. Of course, the exact location may vary depending on the model; refer to the instruction manual and pay attention to the position of the shift key. The shrink wrapper supplier would like to remind everyone that the operating method is very simple: we only need one hand to hold it down. Press the Shift key, and with your other hand, simultaneously pull out the stuck photo.

Now that we’ve mastered the usage, how can we reduce the occurrence of this abnormal phenomenon? Shrink wrapping machine supplier Reminder: When packaging in plastic, we need to pay attention to the following:

1. When using the machine, make sure to place it on a flat, dry surface. Allow sufficient space around the machine. It is not recommended to pull the power cord too straight or too tightly.

2. Use adhesive film of the appropriate size and thickness for the machine. If the adhesive film is too thick, it may cause the laminator to become clogged.

3. Do not use plastic packaging materials that are sensitive to heat, such as fax machine paper, during the plastic molding process in hot-glue mode.

4. Do not insert any metal objects into the machine, nor touch the inside of the machine with your fingers.

5. If the gluing machine has been in use for an extended period, it is recommended to turn it off and let it rest for 30 minutes before using it again.

Only by mastering the correct operating procedures can you better operate the machine. Shrink wrapping machine supplier I hope the above explanation has been helpful to you.